Operation Manual
About this manual
Operating manual 911 - Version 00.0 - 06/2013
7
1 About this manual
1.1 Scope of application of the manual
This manual describes the intended use and set-up of the CNC sewing
unit for free contours 911. It applies to all submodels listed in Section
3 Performance description.
1.2 Applicable documentation
The device contains built-in components from other manufacturers, e.g.
Drive motors. The respective manufacturers have carried out hazard
assessments for these purchased parts and confirmed compliance of the
design with the applicable European and national regulations. The
intended use of the built-in components is described in the corresponding
manuals of the manufacturers.
1.3 Damage during transport
Dürkopp Adler cannot be held liable for any damage during transport.
Check the delivered product immediately after receiving it. Report any
damage to the last transport manager. This also applies if the packaging
is not damaged.
Keep the machines, devices, and packaging material in the condition they
were at the time the damage was identified. That secures any claims
towards the transport company.
Report all other complaints to Dürkopp Adler immediately after receiving
the product.
1.4 Limitation of liability
All information and notes in this operating manual have been compiled in
accordance with the latest technology and the applicable standards and
regulations.
The manufacturer accepts no liability for any damage due to:
• Failure to observe the instructions in the manual
• Improper use
• Unauthorized modifications to the machine
• The deployment of untrained personnel
• Damage during transport
• Using spare parts not approved