Operation Manual

Error and information messages
86
Operating manual 911 - Version 00.0 - 06/2013
6551
6554
6651
6653
6751
6761
Error in upper part position/AD
converter/process error
Internal error
• Switch the machine off and on again
• Software update
• Notify DA Service
6952 Stepper motor driver error
Internal error
• Switch the machine off and on again
• Software update
• Notify DA Service
Communication
7801 Control panel interface communication
• Cable fault
• Cable
• Switch the machine off and on again
• Software update
• Notify DA Service
8151
8156
8159
IDMA error
• Fault
• Controller defective
• Switch the machine off and on again
• Replace the controller
8152
8154
IDMA error
• Internal error
• Switch the machine off and on again
• Software update
• Notify DA Service
8252
8257
8258
8256
8254
ADSP Boot/Xilinx Boot/ Boot error
Fault
• Switch the machine off and on again
8351 Test pins error • Switch the machine off and on again
• Software update
• Notify DA Service
9601 Stop while sewing on the contour
Continue sewing?
• OK button = continue sewing
• ESC button = cancel sewing
9700 Bobbin change flap not closed Close the bobbin change flap
9701 Parallel clamps not lowered • Remove obstacles
• Adjust sensors
9900 Incorrect machine parameter Initialize the data
9901 Incorrect sequences Initialize the data
9902 Incorrect program parameter Initialize the data
Error
code
Description Troubleshooting