Operation Manual

Creating programs with DA CAD 5000
82
Operating manual 911 - Version 00.0 - 06/2013
Saving the seam contour
Figure 57: Save the seam contour
The final step is to save the finished seam program and copy it to a USB stick.
Not all commonly available USB sticks are suitable for the copying
process.
You can obtain a suitable USB stick from Dürkopp Adler using the order
number 9805 791113.
Save the
program on a
USB stick
1. Select the menu items Data transfer > USB memory stick
>
Save (PC->>USB).
After successfully saving to the USB stick the following steps must be
performed at the machine:
Open the
program on
the sewing unit
Transfer the program to the sewing unit
1. Insert the USB stick and copy the desired file to the DAC.
( Section 6.15 Copying a seam program or sequence, page 58)
2. Open the copied program.
( Section 6.5 Opening a seam program or sequence for sewing,
page 47)
3. Adjust the program parameters (especially the sewing foot height).
( Section 6.17.2 Changing the parameters of a seam program,
page 62)
4. Perform a contour test to check the clamp motion.
( Section 6.11 Performing a contour test, page 54)
 Sewing with the program can begin after successful testing/adjustment.
Damage to the machine through exceeding the sewing field size
If you have entered contour points that lie outside the sewing field then
the movement of the clamps during sewing can cause damage to the
machine or the sewing material.
Perform a contour test before sewing using a program created with
DA CAD 5000, to ensure that the entire contour lies within the
permissible sewing field.
ATTENTION