Operation Manual

Operating the controller
Operating manual 911 - Version 00.0 - 06/2013
65
PP3 - Removal mode
Symbol Meaning
Removal mode
The following options can be set:
Mode 1 (Def.)
Clamp is opened in the removal position.
Mode 2
Clamp remains closed in the removal position. The clamp is opened when
the pedal is pressed.
Mode 3
Clamp remains closed in the removal position. Pressing the pedal opens
the left part of the two-piece clamp for angle mounting. Pressing the pedal
again opens the right part.
Mode 4
Clamp remains closed in the removal position. Pressing the pedal opens
the right part of the two-piece clamp for angle mounting. Pressing the pedal
again opens the left part.
Mode 5
Clamp remains closed in the removal position.
Removal position
(On/Off)
With the removal position activated the clamps move to the desired position
for convenient removal of the sewing material after the sewing procedure.
Removal position X
The value range varies depending on the subclass and sewing field size.
Removal position Y
The value range varies depending on the subclass and sewing field size.
PP4 - Softstart
Symbol Meaning
Number of softstart stitches
(min. = 0 .. max. = 10; Def. 5)
Softstart speed
(min. = 100 .. max. 2000; Def. 300 rpm)
PP5 - Needle thread monitor
(min.=0..max.= 99: Def. 5)
Is only active if activated in the machine parameters.
(A higher value makes the needle monitor less sensitive.
99 = Needle thread monitor switched off in this program only.)