Operation Manual

Operating the controller
64
Operating manual 911 - Version 00.0 - 06/2013
PP2 - Insertion mode
Symbol Meaning
Insertion mode
The following options can be set:
Mode 1 (Def.)
Clamp is opened in the insertion position. The clamp is closed when the
pedal is pressed. Pressing the pedal again starts sewing of the seam.
Mode 2
Clamp is opened in the insertion position. Pressing the pedal closes the left
part of the two-piece clamp for angle mounting. Pressing the pedal again
closes the right part. Pressing the pedal again starts sewing of the seam.
Mode 3
Clamp is opened in the insertion position. Pressing the pedal closes the
right part of the two-piece clamp for angle mounting. Pressing the pedal
again closes the left part. Pressing the pedal again starts sewing of the
seam.
Mode 4
Quick-start mode:
Clamp is opened in the insertion position. The clamp is closed and sewing
of the seam is started when the pedal is pressed. With the alternating
clamp the seam is automatically started after insertion.
This mode is only active when quick-start is enabled in the machine
parameters. The machine must be switched off and on in order to enable
the quick-start mode.
Mode 5
Clamp is remains closed in the insertion position. Pressing the pedal again
starts sewing of the seam.
Insertion position
(On/Off)
With the insertion position activated the clamps move to the desired
position for convenient insertion of the sewing material.
Insertion position X
The value range varies depending on the subclass and sewing field size.
Insertion position Y
The value range varies depending on the subclass and sewing field size.