Operation Manual

Operating the controller

Operating manual 911 - Version 00.0 - 06/2013

6.17.2 Changing the parameters of a seam program

You can also change the general settings that apply to the entire seam

program.

Select the

parameter

group

1. Tap the menu items Edit > Seam program > Parameters.

The window for selecting the program parameter group appears:

Figure 46: Select the program parameter group

Changing

program

parameters

2. Tap the desired parameter group.

The individual parameters of this group are displayed.

3. Tap the desired parameter.

The window for modifying the parameter value opens.

4. Set the parameter to the desired value.

( Entering parameter values, page 45)

There are 8 program parameter groups:

Symbol Parameter group

PP1 - Configuration

General settings

PP2 - Insertion mode

Insertion mode and position

PP3 - Removal mode

Removal mode and position

PP4 - Softstart

Number of stitches and speed

PP5 - Needle thread monitor

Sensitivity value for the needle thread monitor

PP6 - Thread consumption

Values for determining thread consumption

PP7 - Offset:

Contour is offset in a particular direction

PP8 - Scaling:

The size of the contour is changed.