Operation Manual

Operating the controller
Operating manual 911 - Version 00.0 - 06/2013
61
Figure 45: Technology operations
Select
technology
operations
6. Select the desired technology operations for the new seam path
( Section 6.4.5 Selecting options from a list, page 42).
7. Confirm the selection with
OK.
You are returned to the detail window with the modified contour.
8. Tap the
Next button again.
A query dialog is displayed, asking if you wish to adopt the changes.
Agreeing to this dialog will save the modified contour.
Important: Always perform a contour test every time after modifying a
contour to ensure that the new seam path lies within the permissible
sewing field. ( Section 6.11 Performing a contour test, page 54).
Damage to the machine through exceeding the sewing field size
If you have entered contour points that lie outside the sewing field then
the movement of the clamps during sewing can cause damage to the
machine or the sewing material.
Always perform a contour test every time after creating or editing a
contour to ensure that the entire contour lies within the permissible
sewing field.
ATTENTION