Operation Manual

Operating the controller
50
Operating manual 911 - Version 00.0 - 06/2013
6.8 Continuing a seam in Repair mode after an error
In Repair mode you can move to any desired point on the contour, e.g. in
order to continue the seam program from this position after an error has
occurred.
Repair Mode 1. Tap the Repair mode button on the main screen.
The
Repair mode window is displayed.
Figure 35: Repair Mode
Correcting
errors
2. Use the Forwards and Back buttons to move to the point where
sewing is to continue.
3. Tap the
Continue Sewing button.
The program jumps back to the main screen and sewing of the
seam continues from the selected point.
6.9 Resetting the counter
Depending on the machine parameter settings the counter counts the
sewn programs or sequences up or down. You can use
Reset
Counter button to reset the counter to the start value ( Section MP6
- Counters, page 71).
Reset
Counter
1. Tap the Reset Counter button on the main screen.
The counter is reset to the value defined in the machine parameters.