Operation Manual

Operating the controller
Operating manual 911 - Version 00.0 - 06/2013
49
6.7 Changing the bobbin
The machine automatically detects when the looper thread has been used
up and a new bobbin needs to be inserted.
In this case, or when a thread breakage occurs, the
Manage Thread
Breakage window is automatically displayed.
Figure 34: Managing a thread breakage
Changing the
bobbin
1. Tap the Change Bobbin button.
2. Changing the bobbin ( Section 5.9 Replacing the looper thread
bobbin, page 31).
3. Use the Forwards and Back buttons to move to the point where
sewing is to continue.
4. Tap the
Continue Sewing button.
The program jumps back to the main screen and sewing of the
seam continues from the selected point.
Bobbin change without a request from the program
If you wish to independently insert a new bobbin without being requested
to do so by the program, e.g. when changing color, then you must tap the
Bobbin change l button on the main screen after changing the
bobbin to inform the program that a new bobbin has been inserted and that
the thread consumption must resume counting from the value
corresponding to the full bobbin capacity.
Updating the bobbin capacity
After a color
change
1. Tap the Bobbin Change button on the main screen.
The counter for the bobbin capacity begins anew with a full bobbin.
Risk of injury by the needle point or moving parts.
Switch the sewing machine to the Safe Stop mode
before changing the bobbin.
WARNING