Operation Manual

Operating
Operating manual 911 - Version 00.0 - 06/2013
27
5.6 Threading in the needle thread
Figure 9: Threading in the needle thread part 1
Steps
1. Place the thread reel on the thread reel holder and guide the needle
thread through the hole in the guide on the unwinding bracket.
Important: The unwinding bracket must be parallel to the thread stand.
2. Insert the thread through the guide (11): From the rear to the front
through the uppermost hole, from the front to the rear through one of
the middle holes, from the rear to the front through one of the lower holes.
3. Feed the thread counterclockwise around the tensioner (10).
4. Feed the thread clockwise around the tensioner (9).
5. Insert the thread through the thread guides (7) and (8).
6. Feed the thread clockwise around the diverter (6).
7. Feed the thread under the thread tensioning spring (5), through the
guide (3) and through the thread regulator (2) to the thread lever (1).
8. Feed the thread through the thread lever (1) and thread guide (4).
Risk of injury by the needle point and moving parts.
Switch off the sewing machine before inserting the thread.
WARNING
(1) - Thread lever
(2) - Thread regulator
(3) - Guide
(4) - Guide
(5) - Thread tensioning spring
(6) - Diverter
(7) - Guide
(8) - Guide
(9) - Tensioner
(10) - Tensioner
(11) - Guide
཰
ཱ
ི
ཱི
ཱུ
ྲྀ
ཷ
ླྀ
ཹ
ེ
ུ