Operation Manual

Setting up
Operating manual 911 - Version 00.0 - 06/2013
103
10.10 Commissioning
Carry out a sewing test before starting up the machine.
Adjust the machine to the requirements of the material to be sewn.
To do this, read the corresponding sections in the  Operating manual
Read the corresponding sections in the  Service manual in order to
make adjustments to the machine if the sewing results do not conform to
the requirements.
Performing a sewing test
1. Switch off the sewing machine at the main switch.
2. Threading in the needle thread
( Section 5.6 Threading in the needle thread, page 27).
3. Thread in the hook thread.
( Section 5.8 Winding the looper thread, page 30).
4. Switch on the sewing machine at the main switch.
The controller is initialized.
5. Press the pedal forwards.
The reference run starts.
The transport carriage moves to the reference position.
The reference run is necessary in order to obtain a defined starting
position of the transport carriage.
Pressing the pedal forwards triggers the different steps of the insertion
procedure one after another and then starts the sewing process.
For selecting the seam program and other controller settings
 Section 6 Operating the controller, page 35.
Risk of injury by the needle point or moving parts.
Switch off the sewing machine before replacing the needle,
insert the thread, insert the hook thread reel, adjust the hook
thread tension and the thread regulator.
WARNING
Possible machine damage through transportation without sewing
material
Moving the transport carriage without sewing material damages the
transport clamp coating.
Ensure that sewing material is present under the transport clamps
ATTENTION