Operation Manual

Setting up
98
Operating manual 911 - Version 00.0 - 06/2013
10.4.2 Frames without rollers
The working height is continuously adjustable between 760 and 910 mm
(clearance between the floor and upper edge of the table plate).
Figure 64: Setting the working height on sewing units without rollers
1. Support the unit with a lifting carriage or forklift.
2. Loosen all 4 nuts (1) on the table legs.
3. Adjust the table plate level to the desired working height by turning the
threaded rods (2).
Important: Turn the threaded rods (2) evenly at both sides to prevent
jamming.
4. Tighten all 4 nuts (1).
5. Remove the lifting carriage or forklift.
Risk of injury
The machine is heavy
Do not lift the sewing unit by the table plate. Always support
the unit using a lifting carriage or forklift before releasing the
clamping screws.
WARNING
(1) - Nut (2) - Threaded rod
཰
ཱ