Operation Manual

Setup
96 Operating Instructions 911-210 - 01.0 - 11/2015
8.4.2 Frames without rollers
The working height is continuously adjustable between 760 and 910 mm
(clearance between the floor and upper edge of the table plate).
Fig. 69: Setting the working height on machines without rollers
1. Support the unit with a lifting carriage or forklift.
2. Loosen all 4 nuts (1) on the table legs.
3. Adjust the table plate level to the desired working height by turning the
threaded rods (2).
Important: Turn the threaded rods (2) evenly at both sides to prevent
jamming.
4. Tighten all 4 nuts (1).
5. Remove the lifting carriage or forklift.
Risk of injury.
The machine is heavy.
Do not lift the machine by the table plate. Always support the
unit using a lifting carriage or forklift before releasing the
clamping screws.
WARNING
(1) - Nut (2) - Threaded rod
①
②