Operation Manual

Setup
Operating Instructions 911-210 - 01.0 - 11/2015 95
8.4 Setting the working height
8.4.1 Frame with rollers
The working height is continuously adjustable between 800 and 1050 mm
(clearance between the floor and upper edge of the table plate).
Fig. 68: Setting the working height on machiness with rollers
1. Support the unit with a lifting carriage or forklift.
2. Loosen all 8 clamping screws (1) on the table legs.
3. Set the table plate level to the desired working height.
Important: Pull out or push in the frame tubes evenly at both sides to
prevent jamming.
4. Tighten all 8 clamping screws (1).
5. Remove the lifting carriage or forklift.
Risk of injury.
The machine is heavy.
Do not lift the machine by the table plate. Always support the
unit using a lifting carriage or forklift before releasing the
clamping screws.
WARNING
(1) - Clamping screws
①