Operation Manual

DA-CAD 5000
78 Operating Instructions 911-210 - 01.0 - 11/2015
Saving the seam contour
Fig. 57: Save the seam contour
The final step is to save the finished seam program and copy it to a USB
stick.
Important: Not all commonly available USB sticks are suitable for the
copying process.
You can obtain a suitable USB stick from Dürkopp Adler.
Save the
program on
a USB stick
1. Select the menu items Data transfer > USB memory stick
>
Save (PC->>USB).
After successfully saving to the USB stick the following steps must be per-
formed at the machine:
Open the
program on
the machine
Transfer the program to the machine
1. Insert the USB stick and copy the desired file to the DAC,
 5.15 Copying a seam program or sequence, p. 52.
2. Open the copied program,
 5.5 Opening a seam program or sequence for sewing, p. 41.
3. Adjust the program parameters (especially the sewing foot height),
 5.17.2 Changing the parameters of a seam program, p. 56.
4. Perform a contour test to check the clamp motion,
 5.11 Performing a contour test, p. 48.
Damage to the machine through exceeding the sewing field size.
If you have entered contour points that lie outside the sewing field then
the movement of the clamps during sewing can cause damage to the
machine or the sewing material.
Perform a contour test before sewing using a program created with
DA-CAD 5000, to ensure that the entire contour lies within the
permissible sewing field.
NOTICE