Operation Manual

About these instructions
6 Operating Instructions 911-210 - 01.0 - 11/2015
Lists are marked by bullet points.
Result of performing an operation
Change on the machine or on the display/control panel.
Important
Special attention must be paid to this point when performing a step.
Information
Additional information, e.g. on alternative operating options.
Sequence
Specifies the work to be performed before or after a setting.
References
 Reference to another section in these instructions.
Safety Important warnings for the machine users are specially designated.
Since safety is of particular importance, hazard symbols, levels of
danger and their signal words are described separately in the chapter
Safety ( p. 9).
Orientation If no other clear location markers are used in a diagram, indications of
right or left are always from the operator's point of view.
1.3 Other documents
The machine includes components from other manufacturers. Each man-
ufacturer has performed a hazard assessment for these purchased parts
and confirmed their design compliance with applicable European and na-
tional regulations. The proper use of these components is described in
each manufacturer's instructions.
1.4 Liability
All information in these instructions was compiled with consideration to the
state of the art, and applicable standards and regulations.
Dürkopp Adler cannot be held liable for damage resulting from:
• Breakage and damage during transport
• Failure to observe these instructions
• Improper use
• Unauthorized modifications to the machine
• Use of untrained personnel
• Use of unapproved replacement parts
•
