Operation Manual

Settings via software
56 Operating Instructions 911-210 - 01.0 - 11/2015
5.17.2 Changing the parameters of a seam program
You can also change the general settings that apply to the entire seam
program.
Select the
parameter
group
1. Tap the menu items Edit > Seam program > Parameters.
 The window for selecting the program parameter group appears:
Fig. 46: Select the program parameter group
Changing
program
parame-
ters
2. Tap the desired parameter group.
 The individual parameters of this group are displayed.
3. Tap the desired parameter.
 The window for modifying the parameter value opens.
4. Set the parameter to the desired value.
( Entering parameter values, page 39)
There are 8 program parameter groups:
Symbol Parameter group
PP1 - Configuration
General settings
PP2 - Insertion mode
Insertion mode and position
PP3 - Removal mode
Removal mode and position
PP4 - Softstart
Number of stitches and speed
PP5 - Needle thread monitor
Sensitivity value for the needle thread monitor
PP6 - Thread consumption
Values for determining thread consumption
PP7 - Offset:
Contour is offset in a particular direction