Operation Manual

Settings via software
46 Operating Instructions 911-210 - 01.0 - 11/2015
Selecting the line type
Select the
line type
4. Use the line selection buttons (8) to select the type of line to be defined:
•
Seamless path:
The clamps move over this path to the next position without sewing.
•
Straight seam:
A straight path is sewn.
•
Curved seam:
A curve is sewn.
 After tapping the button for a straight or curved seam the correspond-
ing window for entering the seam parameters for this path opens.
Defining the seam parameters for the path
Fig. 37: Teach-In: Seam parameters
Selecting the seam parameters for the path
Defining
the param-
eters
5. Tap the respective parameter.
 The window for entering the parameter value opens.
6. Enter the desired value for the parameter.
( Section Entering parameter values, page 39)