Operation Manual

Operation
Operating Instructions 911-210 - 01.0 - 11/2015 21
After inserting a thicker needle
• Damage to the hook tip
• Damage to the needle
4.6 Threading in the needle thread
Fig. 9: Threading in the needle thread part 1
1. Place the thread reel on the thread reel holder and guide the needle
thread through the hole in the guide on the unwinding bracket.
Important: The unwinding bracket must be parallel to the thread
stand.
2. Insert the thread through the guide (11): From the rear to the front
through the uppermost hole, from the front to the rear through one of
the middle holes, from the rear to the front through one of the lower
holes.
3. Feed the thread counterclockwise around the tensioner (10).
4. Feed the thread clockwise around the tensioner (9).
5. Insert the thread through the thread guides (7) and (8).
6. Feed the thread clockwise around the diverter (6).
7. Feed the thread under the thread tensioning spring (5), through the
guide (3) and through the thread regulator (2) to the thread lever (1).
Risk of injury by the needle point or moving parts.
Switch off the machine before inserting the thread.
WARNING
(1) - Thread lever
(2) - Thread regulator
(3) - Guide
(4) - Guide
(5) - Thread tensioning spring
(6) - Diverter
(7) - Guide
(8) - Guide
(9) - Tensioner
(10) - Tensioner
(11) - Guide
①
②
③
④
⑥
⑦
⑧
⑨
⑩
⑪
⑤