Operation Manual

STL: (Stitch length)

Stitch length within the seam course.

Input: 0 ...

Fspg. (Thread tension)

Input: 0 ... 100 (standard = 50)

FA: (Thread trimming)

Cut the thread after the end of the seam course or not.

Input: 0 = no cutting

1 = cutting

–

Switch to the display of coordinates with the key “ð ”.

With the keys “ ï”, “ð ”, “ñ ” and “ò ” the circular arcs of the seam

contour are fixed in steps of 0.5 mm.

By stepping the pedal forward and with the keys “ï”, “ð ”, “ñ ” and

“ò ” the individual seam sections can be fixed in steps of 1.0 mm.

–

Move to the first coordinate point 1 with the keys “ï”, “ð ”, “ñ ”,

“ò ” or by stepping the pedal forward and with the keys “ï”, “ð ”,

“ñ ” and “ò ” and determine this as non-sewing line.

Note

Point 1 is the last point of the prior seam course.

–

Press the “OK” key.

–

Move to the second coordinate point 2 with the keys “ ï ”, “ð ”, “ñ ”

,“ò ” o r by s tepping the pedal forward and with the k eys “ï”, “ð

”, “ñ ” and “ò ”.

–

Press the “OK” key.