Operating instructions

Settings via the software
Operating instructions 906 - Version 00.0 - 05/2014
83
7.11 Performing a contour test
After creating or changing a program or changing a seam contour, perform
a contour test. Ensure that the contour lies within the limits of your partic-
ular unit by performing a contour test.
Checking a contour
1. Lay the material under the transfer plate and lower the transfer plate by
using the foot pedal.
2. Tap the menu items Edit > Seam program > Contour test.
 The Contour test window opens.
Figure 57: Contour Test
3. Use two-hand control.
4. Move along the contour stitch by stitch using the Forwards and Back
buttons.
5. Check that all points lie within the sewing area.
ATTENTION
Damage to the machine by exceeding the sewing field size
If you have entered contour points that lie outside the sewing field then
the movement of the clamps during sewing can cause damage to the
machine or the sewing material.
After creating or changing a program, perform a contour test. This way,
you can check whether the entire contour lies within the range of the
possible sewing field.