Operating instructions

Settings via the software
Operating instructions 906 - Version 00.0 - 05/2014
81
Seam parameters for teach-In
Drawing a path
7. Use the arrow buttons to move the cursor to the end point of the desired
path.
Alternatively, you can tap an arrow button once in order to define the
direction and then continue moving in this direction by pressing the
pedal.
Important: Take care to ensure that the contour remains within the
permissible sewing field of your particular sewing unit. Especially with
curved paths, you should remember that the start and end points are
not directly connected and that a curve is generated between these two
points.
8. Tap the OK button.
 The seam path is adopted with the specified parameters.
Adding further seam paths
Further seam paths are defined using the same procedure.
• Add each new seam path by starting at step 4 ( page 80).
Deleting a seam path
• Tap the Delete button.
 The last section of the seam path is deleted.
Button Meaning
Speed
Stitch length
Thread tension
Stroke height
Cut thread