Operating instructions

Settings via the software
64
Operating instructions 906 - Version 00.0 - 05/2014
7.3 Starting the software
After switching on the sewing unit at the main power switch and actuating
the two-hand control, the machine performs a reference run. After this, the
startup screen is shown on the operating terminal for a few seconds.
Figure 38: Startup screen
Using the start screen, you can select the user interface language or use
Service to quickly switch to the Multitest menu.
Both functions can also be accessed later from within the program via the
menu items Extras > Service.
( Testing MultiTest machine functions, page 108)
( Changing the language, page 106)
If you do not tap any buttons, the display automatically switches to the
main screen after a few seconds.
Buttons on the main screen
Button Function Submenu items Described on
Continue sewing the contour from a particular point Repair mode
 page 78
Define announcement of the bobbin change.
The thread consumption is set in meters for this.
Bobbin change
 page 77
Reset counter to a particular value Reset counter
 page 78
①②
(1) - Language selection button (2) -Multitest fast access