Operating instructions

Setting up
60
Operating instructions 906 - Version 00.0 - 05/2014
6.7 Commissioning
Conduct a sewing test before starting up the machine. Adjust the machine
to the requirements of the material to be sewn.
To do this, read the corresponding sections in the  Operating instruc-
tions. Read the corresponding sections in the  Service manual in order
to make adjustments to the machine if the sewing results do not conform
to the requirements.
Performing a sewing test
1. Switch off the sewing unit at the main switch.
2. Thread needle thread
( 5.7 Threading the needle, page 30).
3. Thread hook thread
( 5.9 Winding the hook thread, page 33).
4. Switch on the sewing unit at the main switch.
 The controller is initialized.
5. Use two-hand control.
 The reference run starts.
The transport carriage moves to the reference position.
The reference run is necessary in order to obtain a defined starting posi-
tion of the transport carriage.
Pressing the pedal forwards triggers the different steps of the insertion
procedure one after another and then starts the sewing process.
For selecting the seam program and other controller settings see
 7 Settings via the software, page 61.
WARNING
Risk of injury by the needle point or moving
parts.
Switch off the sewing unit before replacing the nee-
dle, insert the thread, insert the hook thread bob-
bin, adjust the hook thread tension and the thread
regulator.
ATTENTION
Possible machine damage through transport without sewing
material
Moving the transport carriage without sewing material damages the
transport clamp coating.
Ensure that sewing material is present under the transport clamps
before starting sewing.