Operating instructions

Setting up
Operating instructions 906 - Version 00.0 - 05/2014
53
6.3.3 Installing the automatic stacker
Figure 32: Installing the automatic stacker
1. Remove threaded screws (2) and cover plate (3).
2. Place support pipe (4) into the fork bracket and align the stacker so that
the bars are a sufficient distance away from the table top.
3. Place cover plate (3) on top and screw tightly with six threaded screws
(2) (screwdriver width 10 mm).
4. Tighten both setscrews (1) so that the stacker is positioned in the fork
bracket free of play (screwdriver width 5 mm).
5. Install the equipotential bonding (7):
• Loosen hexagonal socket screw (screwdriver width 4 mm)
• First place the washer, then the ring cable lug of the equipotential
bonding and finally the toothed lock washer onto the hexagonal
socket screw and screw it tightly to the support pipe (4).
6. Attach the plugs of the valve control lines (6).
• The allocation is clear from the labeling.
7. Connect the compressed air hose on the valve block to the pneumatic
connection (5).
WARNING
Risk of injury.
The automatic stacker is heavy and has bulky
dimensions.
Carry out the installation with two people in order to
avoid back injuries or crushing injuries if the
machine falls down.
(1) - Setscrews
(2) - Threaded screws
(3) - Cover plate
(4) - Support pipe
(5) - Pneumatic connection
(6) - Plug for valve control lines
(7) - Equipotential bonding
⑤
⑥
③
②
④
⑦
②
①