Operating instructions

Operation
30
Operating instructions 906 - Version 00.0 - 05/2014
Faults caused by an incorrect hook clearance
• After inserting a thinner needle:
• Missing stitches
• Thread damage
• After inserting a thicker needle:
• Damage to the hook tip
• Damage to the needle
5.7 Threading the needle
Figure 12: Threading in the needle thread part 1
Steps
1. Place the thread reel on the thread reel holder and guide the needle
thread through the hole in the guide on the unwinding bracket.
Important: The unwinding bracket must be parallel to the thread stand.
2. Insert the thread through the guide (11): From the rear to the front through
the uppermost hole, from the front to the rear through one of the middle
holes, from the rear to the front through one of the lower holes.
3. Feed the thread counterclockwise around the tensioner (10).
WARNING
Serious injuries can be caused by the machine
suddenly starting up.
Turn off the machine before threading.
Do not touch the tip of the needle.
(1) - Thread lever
(2) - Thread regulator
(3) - Guide
(4) - Guide
(5) - Thread tensioning spring
(6) - Diverter
(7) - Guide
(8) - Guide
(9) - Tensioner discs
(10) - Tensioner discs
(11) - Guide
①
④
②
⑤
③
⑪
⑧
⑩
⑦
⑨
⑥