Instruction manual

4.3 Fitting the belt guards

–

Disassembly the hand wheel (1).

–

In the machines with the motor on the table top mount the

guard (2) on t he machine head (the guard is included in of the

motor part set) and mount the guard (3) on the motor (the guard is

included in the motor package).

–

In the machines with the motor on the sewing head and with

1,55:1 toothed belt driving gear, mount the proximity switch (6). It

is included in the “kit for motor“.

–

In all machines with the motor on the machine head mount the

guards (4) and (5) (they are included in of the motor part set).

–

Mount the hand wheel (1). Doing this, observe the correct angle

position: if the needle is in the upper dead point, there should be

the 0° value on the hand wheel scale.