Operation Manual

4.7 Fitting the connecting cable, control panel and sewing diode lamp

on the machine head

–

The connecting cable 1 is supplied with every machine with the

positioning motor (drive).

–

The control panel 2 had to be ordered separately (optional

equipment). When ordering a control panel, a bracket 3 is always

supplied together with it.

–

The sewing lamp LED 5 is an optional equipment. Two types of

brackets are supplied together with it to enable the installation of

the lamp in two positions.

Position 5 is the basic one.

Position 7 should be used if a guide for sewing material is

mounted on the machine.

–

Dismantle the upper cover and back cover of the machine head.

–

Install the connecting cable with the connector 1 according to the

picture.

–

Install the control panel 2 with the bracket 3 and install the cable 4

according to the picture.

–

Mount the sewing lamp 5 and install the cable 6 according to the

picture.

–

Push the cables through the table top and attach them with a

self-sticking clip 8.