Operation Manual

4.3 Fitting the belt guards

–

Disassembly the hand wheel 1.

–

In the machines with the motor on the table top mount the guard 2

on the machine head (the guard is included in of the motor part

set) and mount the guard 3 on the motor (the guard is included in

the motor package).

–

In the machines with the motor on the sewing head and with

1,55:1 toothed belt driving gear, mount the proximity switch 6. It is

included in the “motor parts set“.

–

In all machines with the motor on the machine head mount the

guards 4 and 5 (they are included in of the motor part set).

–

Mount the hand wheel 1. Doing this, observe the correct angle

position: if the needle is in the upper dead point, there should be

the 0° value on the hand wheel scale.