Operation Manual

4.2 Fitting the machine head drive with a V-belt

This paragraph applies only to the machines with the motor on the

table top.

–

Mount the V-belt pulley 1 and the V-belt 2. Both items are

included in the accessories.

–

Loosen the screws 3 and stretch the belt. The connecting rod 4

should be vertical approximately.

The surface 5 horizontal approximately.

–

Check the belt tension by force F = 10 N (~ 1 kg). The belt is

expected to bend by 20 mm approximately.

–

Adjust the stop 6 position protecting the belt against falling out

at tilting the machine.

F=10N

20 mm