Operation Manual

3.2.2 Assembling the table top with the motor on the machine head (direct drive)
–
Tur n the t able top 1 upside down.
–
Screw the electric cable channel 2.
–
Screw the pedal position sensor 3.
–
Screw the electric cable clip 4.
–
Put the oil sump on 5 and slide it in the arrow direction 6 till the
relevant protrusions of the oil sump are seated on the recess
contour. Screw the oil sump.
–
Screw the drawer 7.
–
Pre-bore the holes for wood screws and screw the drive control
box 8.
–
Screw the sewing lamp transformer 9 – if there is any.
–
Mount electric cables according to the instructions in chapter 5.
–
Pre-bore the holes 10. Attach the table plate to the stand with
woodscrews (B8 x 35). Then turn the stand to normal position..
–
Insert the yarn stand 11 in the hole in the table plate and secure it
with the nuts and washers. Fit and align the yarn reel and
unwinding holders.
–
Insert the machine head support pin 12.
–
Place the hinge bottoms 13 for the machine head into the cutout
of the table plate 1 and tighten the screws.
–
Insert the wedges 14 in the recess cor ners.
–
Insert the rubber cushions 15.
–
Remove the blind from the bushing 16.
–
Remove the knee lever 17 and guide through the opening, as
shown in the illustration.
6
328
30
80
770
30
72
185
15
368
80
15
4
10 2 69 58 13 10
14
12
15
11
260
13
16
17
460
180
15
7
50