Operation Manual

3.2 Assembling the table top
3.2.1 Assembling the table top in the machine with the motor on the table top
–
Tur n the t able top 1 upside down.
–
Screw the drawer 2.
–
Put the oil sump 3 on the recess in the table top. Slide it in the
arrow direction 4 till the relevant protrusions of the oil sump are
seated on the recess contour. Screw the oil sump.
–
Screw the drive 5.
–
Screw the sewing lamp transformer 6 – if there is any.
–
Screw the cable clip 7.
–
Screw the electric cable channel 8.
–
Screw the switch 9.
–
Mount electric cables according to the instructions in chapter 5.
–
Pre-bore the holes 10. Attach the table plate to the stand with
woodscrews (B8 x 35). Then turn the stand to normal position.
–
Insert the yarn stand 11 in the hole in the table plate and secure it
with the nuts and washers. Fit and align the yarn reel and
unwinding holders.
–
Insert the machine head support pin 12.
–
Place the hinge bottoms 13 for the machine head into the cutout
of the table plate 1 and tighten the screws.
–
Insert the wedges 14 in the recess cor ners.
–
Insert the rubber cushions 15.
–
Remove the blinds from the bushing 16.
–
Remove the knee lever 17 and guide through the opening, as
shown in the illustration.
5
328
28
80
140
770
30
50
185
15
96
368
80
15
110 7 69 58 4 3 10
14
2
12
15
11
260
13
16
17