Operation Manual

6.14.2 Material guide adjustment

–

Adjust the guide element 1 height with a bolt 2. The guide element

is lifted, when tightening the bolt, and vice versa. If the bolt 2

strikes the end of the adjustment range, the latter can be widened

by the bolt 3, loosening the plate 4 shifting to a different position

and its repeated fixing.

–

Adjust the lateral position of the guide element 1 by the bolt

loosening 5, the element shifting, and its repeated fixing.

–

Adjust the guide position in the sewing direction after loosening

the bolt 6. The rear edge of the guide element 1 should be located

in the needle hole center. After adjustment, tighten the bolt 6.