Operating instructions

3. Completing and Screwing on the Table

–

Screw on the reinforcement brace 2 between the

cutouts for the machine head and the motor belt.

–

Screw the cable channel 5 and the mounting for the

wiring tension relief to the underside of the table.

–

Screw on the main switch 6.

–

Screw on the sewing light transformer, if included.

–

Lay the electrical wiring.

–

Screw on the drawer 8 with its mounting.

–

Screw the table onto the frame with B8x35 wood

screws. The positioning of the table to the frame can

be seen in the reference mark on the underside of

the table. See the dimension sketch.

–

Press the bottom hinge parts 3 for the machine

hinges into the recesses in the table and screw fast.

–

For the forward rest of the machine head insert two

rest plugs into the table and slide on pressure

springs. The left plug 1 must be inserted into the

hole as per section C-C and the right plug into the

hole as per detail Y. The ends of the plugs protruding

on the bottom of the table are to be cut off.

Technical Feature!

Through the positioning of the left retainer plug 1 a

lifting of the left machine hinge by ca. 1mm results

and thus an uncoupling from the table.

–

Screw the oil baffle 7 under the table with wood

screws in such a way that there is a gap of 55 mm

between the right edge of the oil baffle and the right

edge of the table cutout. Align the oil baffle to the

front and rear edge of the table cutout in such a way

that the machine head does not hit when tilted over.

The knee lever should later not hit the oil baffle in

any of its possible settings.