Operating instructions

1. If the main switch has in the meantime been turned off
start again as described above. Otherwise press key
G and the minus (-) key at the same time. The display
shows E EINGEBEN (Enter).
2. Tap key F. The display shows 700 *XXXX = number
value of the reference position.
3. Tap key F repeatedly until 702* 0026 appears.
Step down briefly on the pedal. Machine positions in
the position set at the factory.
Turn the handwheel in the machine direction of
rotation and arrest the timing pin in position F (lower
needle position).
4. Pull out the timing pin. Store the value by stepping
down on the pedal. Check position F with the timing
pin. If necessary, e.g. because of the drawn-forward
position of the rotor, repeat the setting again.
Attention!
Because of tolerances the set values shown
for the positions can fluctuate by 0002.
5. Tap key F once. 703* 0205 appears.
Step down on the pedal. Machine positions in the
position set at the factory.
Turn the handwheel in the machine direction of
rotation and arrest the timing pin in position C (upper
thread lever position).
6. Pull out the timing pin. Store the value by stepping
down on the pedal.
Check position C with the timing pin. If necessary
repeat the setting.
7. Press keys G and (-). The display shows * MANUELL.
The machine is operational.
Note!
The control panel makes it possible to show the display in
different languages. For this tap key F to 733. Choose the
desired language with the keys - or +.
Return to the desired parameter with key F.
23