Operating instructions

Attention!

The holes for fastening the handwheel are arranged

asymetrically.

–

When attaching the handwheel insert the timing pin 4

from the accessories package through the hole 3 into

the deeper slot A of the adjustment disk mounted on

the arm shaft.

–

Set the handwheel with letter A at the mark 7 and

turn the screws 8 tight.

–

Set the connecting rod 9 so that the pedal 10

assumes a position of 10 degrees to horizontal, e.g.,

with its forward edge lower and with its rear edge

slightly raised.

–

For ergonomic reasons the pedal, in its sideways

orientation on the frame brace, should be so

fastened that the pedal middle lies under the needle.

4873