Instruction manual

6.1.2 Parameter values for DAC classic

The machine class and subclass choice will be optioned in the mean

time of the SW installation from the extern device “DONGLE”.

The parameter input description you will find in the publication given by

the “DAC eco/classic operating manual” producer or on the website

w ww.duerkopp-adler.com.

To be the machine function regular is to be set up the “reference

position” and Max. sewing speed.

Parameter Value Description of parameter

T08 00 * Max. sewing speed (min

-1

)

T08 10 - Reference position

* depends on the type and machine equipment

6.2 Setting of machine positioning

6.2.1 Position definition

Position 1

The needle is down at seam-stop. The needle thread loop is caught

with the hook. The needle is high enough so that it is possible to lift the

foot to the height 12 mm.

Position 2

The needle is up after trimming. At the foot lifting to the height 12 mm

the needle point must not protrude from the foot fitting surface.

Reference position

On the needle motion downwards, the needle point is at the throat

plate level. This position is used to carry out the positioning motor

basic setting. The above mentioned positions are derived from this as

well as other positions not mentioned here.