Instruction manual

5.1.1 Lighting transformer connection to network voltage

Attention! Danger of electric injury!

The lighting transformer is not switched-off by the main switch

(EN 60 204-31)! At the lighting installation and repair works in the

transformer box, e .g. a fuse replacement, the network plug must be

disconnected from the network unconditionally.

A. The machine is equipped with Efka DC1550/DA321G

–

Pull the network plug form the socket.

–

Screw out 4 screws on the front plate of the control box.

–

Remove the front plate.

–

Pull the cable of the lighting transformer through the canal (1) in

the control box.

–

Take out the black rubber bushing (2).

–

Pierce the bushing with a screwdriver.

–

Pull the lighting transformer cable through the arisen hole.

–

Put the rubber bushing back again.

–

Gradually push the terminal openers (3) and (4) with a small

screwdriver until the terminals (5) and (6) open.

–

Connect the blue conduit (6) to the terminal and brown conduit (5)

to the terminal.

–

Screw the front plate back again.

–

Fix the lighting transformer cable against plucking out

(e.g. w ith a stick tape to the network supply cord).

26 5 1

65 4 3