Instruction manual

Habraken Machines
I
I
I
n
n
n
d
d
d
u
u
u
s
s
s
t
t
t
r
r
r
i
i
i
a
a
a
l
l
l
S
S
S
e
e
e
w
w
w
i
i
i
n
n
n
g
g
g
A
A
A
p
p
p
p
p
p
l
l
l
i
i
i
c
c
c
a
a
a
t
t
t
i
i
i
o
o
o
n
n
n
s
s
s
6 (18)
Main screen
Configuration screen
4 Decorative stitching control unit
Decorative stitching is fully controlled by the so called Decorative Stitching Control Unit. All settings and
selections related to decorative stitching are done here.
In this chapter you will find a description off the user interface.
4.1 Power up
● Power on (Efka main switch)
● The display on the Decorative Stitching Control Unit will show the message “Now booting up”
4.2 Main Screen
● After completion of the boot-sequence, the “main screen”
will be displayed.
● At this stage, decorative stitching isn’t activated yet and
the machine could be operated as a standard twin-needle
DA867 or DA868.
● To activate decorative stitching, press the “zero / one “
button on the lower right corner.
4.3 Configuration Screen
Pressing the “zero / one “ button in the main screen opens
the configuration screen.
The configuration screen offers four selections:
• Pressing the logo will open the “Setup Screen”.
• Selection of either a 1 or 2 needle set. Pressing the
“Change?” button will toggle between the two options
either showing “1 Needle Set” or “2 Needle Set” on the
display.
• Press the “zero / one” button to exit the Configuration
Screen and return back to the main screen.
• Continue to decorative stitch selection. Pressing the
“Continue?” button will open the “Decorative Stitch
Selection” screen.
During configuration, the machine is blocked.
Always check correct threading before pressing continue