Operation Manual

Set-up instructions
Operating instructions 867 - 02.0 - 08/2015 85
7.8 Inserting the machine head
Figure 56: Inserting the machine head
1. Screw the upper hinge parts (2) onto the machine head.
2. Fit the machine head from above at an angle of 45°.
3. Insert the upper hinge parts (2) into the rubber inlays (1).
4. Fold the machine head down and insert it in the recess.
2
1
(1) - Rubber inlays (2) - Hinge upper parts
Risk of crushing.
The machine head is heavy.
Take care not to jam your hands when fitting the
machine head.
This especially applies when fitting the hinge upper
parts into the rubber inlays.
WARNING