Operation Manual

Operating instructions
Operating instructions 867 - 02.0 - 08/2015 31
Short thread
cutter
13. For machines with a short thread cutter:
Insert the thread through the left hole of the thread guide above
the thread clamp.
14. Insert the thread through the left hole of the thread guide below
the thread clamp.
Figure 9: Thread clamp (short thread cutter)
15. Slide thread from the left in the thread clamp, so that the thread
is held in the hooks of the clamp.
The thread should run almost without contact through the thread
clamp. The thread touches only the guides above and below the
thread clamp.
16. Insert the thread through the thread guide on the needle
bar (13).
17. Insert the thread through the needle eye (14) in such a way
that the loose thread end faces the hook.
Short thread
cutter
18. For machines with a short thread cutter:
Pull the thread through the needle eye (14) until the loose
thread end has a length of approx. 4 cm with the thread
catcher (16) in the highest position.
Important:Check the thread length.
The short thread cutter does not function correctly
when the loose thread end is too long.