Operation Manual

Operation
Operating Instructions 867-M PREMIUM - 00.0 - 02/201526
Fig. 8: Winding on the hook thread - part 1
4. Feed the thread counterclockwise from the thread guide (1)
around the preliminary tensioner (2).
5. Insert the thread in a wavelike manner through the 2 holes of
the hook thread guide (4): from bottom to top through the left
hole and from top to bottom through the right hole.
6. Guide the thread to the bobbin (3).
Fig. 9: Winding on the hook thread - part 2
7. Clamp the thread behind the cutter (7) and tear off the loose
end behind it.
8. Fit the bobbin on the bobbin shaft (6).
9. Turn the bobbin clockwise until it clicks.
10. Pull the bobbin lever (5) up.
The hook thread is normally wound on when sewing is in progress.
However, you can also wind on the hook thread without sewing,
e. g. if you require a full bobbin in order to start sewing ( p. 70).
4
3
2
1
(1) - Thread guide
(2) - Preliminary tensioner
(3) - Winder
(4) - Hook thread guide
(5) - Bobbin lever
(6) - Bobbin shaft
(7) - Cutter
⑤
⑥
⑦