Manualshelf

Operation Manual

ManualsBrandsDurkopp Adler ManualsMiscellaneous841
12345678910
About this operating manual
Operating Instructions 841 - 00.0 - 09/2014
5
1.4 Other documents
This equipment includes components from other manufacturers. Each
manufacturer has performed a hazard assessment for these purchased
parts and confirmed their design compliance with applicable European
and national regulations. The proper use of these components is
described in each manufacturer's manual.
1.5 Liability
All information in this operating manual was compiled with consideration
to the state of the art, and applicable standards and regulations.
The manufacturer cannot be held liable for damages resulting from:
• Breakage and transport damages
• Failure to observe operating manual
• Improper use
• Unauthorized modifications to the machine
• Use of untrained personnel
• Use of unapproved replacement parts
1.5.1 Transport
Dürkopp Adler cannot be held liable for breakage and transport damages.
Inspect the delivery immediately upon receiving it. Report any damage to
the last transport manager. This applies even if the packaging is
undamaged.
Leave machines, equipment and packaging material in the condition in
which they were found when the damage was discovered. This will ensure
any claims against the transport company.
Report all other complains to Dürkopp Adler immediately after receiving
the product.
1.5.2 Proper use
The Dürkopp Adler 841-100-01 is a sewing unit for automatic sewing of
buttonholes on the fronts of shirts and blouses. This sewing material
requires needle strengths of 70-100 Nm.
The machine is intended only for use with dry sewing material. The
material must not be thicker than 4 mm and not contain any hard objects.
The stitching is created with synthetic threads with a cotton covering or
synthetic threads.
The sewing machine is intended for industrial use.
The machine may only be set up and operated in dry conditions on well-
maintained premises. If the machine is operated on premises that are not
dry and well-maintained, then further measures may be required which
must be compatible with EN 60204-31:1999.