Operation Manual

Troubleshooting
Operating Instructions 841 - 00.0 - 09/2014
59
4307 Memo dongle Wrong class • Wrong class dongle
attached
• Attach correct dongle
• Format dongle
5101 Contour data
management
EEPROM not
initialized
• Controller
• Controller does not contain
a machine program
• Check the controller
• Install a machine program
5104 Contour data
management
EEPROM
checksum fault
• Controller • Machine performing a reset
automatically.
• Inform DA Service
5301 Contour data
management
No contour data • Cutting length smaller than
length of cutter
• Change parameters
5302 Contour data
management
Data memory full • Too many stitches in con-
tour
• Reduce number of stitches
• Inform DA Service
5303 Contour data
management
Data memory
overflow
• Too many stitches in con-
tour
• Reduce number of stitches
• Inform DA Service
5305 Contour data
management
Storage not
permitted
• Too many stitches in con-
tour
• Reduce number of stitches
• Inform DA Service
5306 Contour data
management
Impermissible
data call
• • Perform a buttonhole contour
reset
• Inform DA Service
5315 Contour data
management
General fault • • Perform a buttonhole contour
reset
• Inform DA Service
6151-6952 I²C/CPU/Mem
Manager
• Fault • Switch the machine off and
on again
• Inform DA Service
7251-7659 ASC/SSC/
RS485
• Fault • Switch the machine off and
on again
• Inform DA Service
8151-8351 IDMA/Xilink/Test
pins
•Fault
(8151-8159: only entry in
event recorder – no other
impairment)
• Switch the machine off and
on again
• Inform DA Service
9700 Machine/
process
Basket not lifted
up
• Basket monitoring sensor
not active
• Check distance to sensor
• Check sensor
9702 Machine/
process
Infeed table not in
transfer position
• Infeed table sensor not
active
• Check ease of movement/
alignment
9703 Machine/
process
Maximum position
exceeded
• Distance between button-
holes too great
• Correct program
Number Location Description Possible cause Remedial action