Operation Manual

Installation
52
Operating Instructions 841 - 00.0 - 09/2014
7.8.2 Setting operating pressure
Figure 18: Setting operating pressure
1. Pull the adjustment knob (1) up.
2. Set the operating pressure so the pressure indicator (2) shows 6 bar:
• To increase pressure: Turn the adjustment knob (1) clockwise.
• To reduce pressure: Turn the adjustment knob (1) counterclockwise.
3. Push the adjustment knob (1) down.
7.9 Checking the lubrication
All wicks and felt bits of the upper section are soaked in oil at the factory.
This oil is conveyed to the reservoir during use. which is why you should
avoid filling too much oil during initial filling.
1. Checking the lubrication ( 5.12.2 Lubrication, page 31).
Adjusting the hook lubrication
To ensure reliable lubrication during infeed time, a relatively large amount
of oil is set at the factory.
1. Check the oil quantity and adjust this, if necessary.
ATTENTION
Machine damage possible due to incorrect pressure.
The operating pressure for the pneumatic unit is 6 bar.
Make sure that the operating pressure is set correctly before putting the
machine into operation.
0
2
8
4
6
10
w
q
(1) - Adjustment knob (2) - Pressure indicator