Operation Manual

Installation
Operating Instructions 841 - 00.0 - 09/2014
51
7.8 Pneumatic connection
7.8.1 Fitting the maintenance unit
The pneumatic unit is an additional component that is not part of the stan-
dard delivery package.
Figure 17: Connecting the pneumatic unit
1. Attach the maintenance unit (2) to the upper cross bar (4) of the frame
using the bracket, screws and clip.
2. Connect the machine hose (1) coming out of the upper section to the
maintenance unit (2) at top right.
3. Connect the system connection tube (3) to the pneumatic system.
ATTENTION
Machine damage possible due to incorrect pressure.
The system pressure for the pneumatic unit is 8 - 10 bar.
Make sure that the system pressure is set correctly before fitting the
pneumatic unit.
0
2
8
4
6
10
r
q
w
e
(1) - Machine hose
(2) - Maintenance unit
(3) - System connection tube
(4) - Cross bar