Operation Manual

Installation
Operating Instructions 841 - 00.0 - 09/2014
49
7 Installation
7.1 Checking the scope of delivery
The delivery scope will vary according to your order.
1. Check that all parts required are present.
7.2 Removing transport securing devices
All transport securing devices must be removed prior to setup.
1. Remove the lashing straps and wooden blocks from the machine upper
section, the table, and the frame.
2. Remove the support wedges between the machine arm and needle
plate.
7.3 Positioning the sewing unit
The sewing unit can be aligned using the screws on the rear right table leg.
Make sure the table is horizontal.
1. Place the spirit level on the frame.
2. Release the screws on the table leg.
3. Align the table plate horizontally
4. Fasten the screws on the table leg.
7.4 Assembling thread reel holder
1. Insert the thread reel holder into the hole on the thread reel holder
bracket.
2. Fasten the thread reel holder using nuts and washers.
3. Fit the thread reel holder and unwinding bracket align these.
WARNING
Risk of injury
The machine may be installed only by trained spe-
cialists.
Wear safety gloves and safety shoes when
unpacking and installing.