Operation Manual

Settings via the software
46
Operating Instructions 841 - 00.0 - 09/2014
6.6.7 Outer tacking parameters, tacking type G
6.6.8 Simple tacking parameters, tacking type H
The parameters are set in the buttonhole seam parameter.
Tacking width
Right offset
(Offset r)
P 6.4/P 7.4
–1.0 … 1.0 mm • The width of the tacking is defined via the width of the but-
tonhole. The width of the tacking can be enlarged to the
right using the right offset.
Tacking width
Offset left
(Offset l)
P 6.5/P 7.5
–1.0 … 1.0 mm • The width of the tacking is defined via the width of the but-
tonhole. The width of the tacking can be enlarged to the left
using the left offset.
Speed 200 ...
4000 rpm
• Sewing speed when creating the cross tacking; tacking
cannot be sewn faster than the buttonhole seam
Symbol Parameters Values Meaning
Symbol Parameters Values Meaning
Tacking width
(width)
P 6.5/P 7.5
2.0 … 6.0 mm • Outer diameter of eyelet
Speed 200 ...
4000 rpm
• Sewing speed when creating the cross tacking; tacking
cannot be sewn faster than the buttonhole seam
Symbol Parameters Values Meaning
Buttonhole seam
stitch distance
(stitchleng.)
P4.2
0.3...1.5 mm • Distance in y-direction for a double stitch
Buttonhole width
(Bhwidth)
P4.3
0.5...6.0 mm • Total buttonhole width
Basting stitches length
(stitchleng)
P 4.6
0.3 … 3.0 mm • stitch distance of basting stitches
Basting stitches
(bastst.)
Start/End/No • Start: Basting stitches at start of buttonhole seam
Select number of runs (1-4)
• End: End of buttonhole seam
• No: no basting stitches