Operation Manual

Settings via the software
44
Operating Instructions 841 - 00.0 - 09/2014
6.6.1 Cross tacking (horizontal) parameters, tacking type A
6.6.2 Circular tacking (to center point) parameters, tacking type B
6.6.3 Tapered tacking parameters, tacking type C
Symbol Parameters Values Meaning
Tacking stitch
distance
(distance)
P 6.2/P 7.2
0.2 … 1.0 mm • Distance in y-direction for a double stitch
Tacking length
(length)
P 6.3/P 7.3
0.6 … 6.0 mm • Length of tacking in y-direction
Parameter P7.3 can only be input when upper/lower tack-
ing types are different
Tacking width
Right offset
(Offset r)
P 6.4/P 7.4
–1.0 … 1.0 mm • The width of the tacking is defined via the width of the but-
tonhole. The width of the tacking can be enlarged to the
right using the right offset.
Tacking width
Offset left
(Offset l)
P 6.5/P 7.5
–1.0 … 1.0 mm • The width of the tacking is defined via the width of the but-
tonhole. The width of the tacking can be enlarged to the left
using the left offset.
Speed 200 ...
4000 rpm
• Sewing speed when creating the cross tacking; tacking
cannot be sewn faster than the buttonhole seam
Symbol Parameters Values Meaning
Number of tacking
stitches
(St.no)
P 6.6/P 7.6
2 … 50 • Number of stitches used for semi-circular-shaped tacking.
Speed 200 ...
4000 rpm
• Sewing speed when creating the cross tacking; tacking
cannot be sewn faster than the buttonhole seam
Symbol Parameters Values Meaning
Tacking stitch
distance
(distance)
P 6.2/P 7.2
0.2 … 1.0 mm • Distance in y-direction for a double stitch
Tacking length
(length)
P 6.3/P 7.3
0.6 … 9.0 mm • Length of tacking in y-direction