Operation Manual

Settings via the software
42
Operating Instructions 841 - 00.0 - 09/2014
*) Only visible if P9 (knit fabric) is switched on.
Buttonhole seam parameters
Lower tacking
P7
• Set the final tacking
Double run
P8
On/Off • Switches double sewing of the entire buttonhole on or off
Knit fabric
P9
On/Off • Switch knit fabric mode on/off
Basting stitches
P10*
• Show number of basting stitches and properties
Zigzag runs
(ZZ runs)
P11*
• Set 2nd zigzag run and show properties
Cut
P12*
• Cutting in the last run
• Cutting in the last but one run
• Cutting during both runs
Copying off
P13
0 … 50 • Buttonhole data for selected buttonhole number is copied to
the currently active buttonhole
Symbol Parameters Values Meaning
Symbol Parameters Values Meaning
Width of
intermediate fabric
(intermediate fabric)
P4.1
-1.0...+1.0 mm • Distance between buttonhole seam inner stitches
Buttonhole seam
stitch distance
(stitch leng.)
P4.2
0.3...1.5 mm • Distance in y-direction for a double stitch
Buttonhole width
(bh.width)
P4.3
1.6...6.0 mm • Total buttonhole width (outer stitches)
Cut
P4.5
On/Off • On: Cutting open during sewing cycle
• Off: No cutting open
Length before cut
(see above)
P4.6
-P6.3...5.9 mm 1. correction of position of first tacking at end of cut
2. Additional buttonhole seam length before cut with
asymmetrical opening cut within the buttonhole